Skip to main content
All CollectionsMARKERSACRYLIC Markers
MONTANA Acrylic Marker Technical Information
MONTANA Acrylic Marker Technical Information
Updated over a week ago
MONTANA-ACRYLIC-MARKER-0.7MM-Group.jpg

GENERAL INFORMATION

Montana Acrylic Marker are available in 5 different tips sizes: 0,7mm, 2mm, 15mm, 30mm and 50mm.

Note: Always test beforehand, if surface/material is compatible!

FEATURES

- Waterbased

- Weatherproof when dry

INSTRUCTIONS FOR USE

Shake the markers vigorously for 2-3 minutes before use...

APPLICATION INFORMATION

- Surfaces should be dry and clean of oil, dirt or rust

- Always perform a test on a non-visible area

PRODUCT INFORMATION

PRODUCT NAMES: Montana ACRYLIC Markers

HS CODE: 96082000

COUNTRY OF ORIGIN: Japan

TECHNICAL INFORMATION

CONTENT: See "INK FILLING VOLUMES" below.

LAQUER BASE: Water-based Acrylic

GLOSS LEVEL (60° angle according to DIN 67530): 5-10 GE matte

HEAT RESISTANCE: Up to 80°C (176°F)

COVERAGE: Good

OVERPAINTING: Can be overpainted with Nitro-Combi (NC) or Acrylic Lacquer after approx. one hour drying time

DRYING TIME AT 20°C (68°F) AND 50% RELATIVE HUMIDITY:

- Dust/Touch dry: approx. 4-5/10 min.

- Overpainting after 1h.

- Fully cured after 6h

Drying time depends on temperature, humidity and thickness of coating.

OPTIMAL PROCESSING CONDITIONS:

- Temperature 10° - 25°Celcius

- Surface temperature 5° - 40°Celcius

- Air humidity max. 60%

INK FILLING VOLUMES

MARKER SIZE

STANDARD COLORS

METALLIC COLORS

0,7mm

5g

3g

2mm

8g

5g

15mm

45g

30g

30/50mm

45g

30g

FREQUENTLY ASKED QUESTIONS

When should I use a primer?

The goal of priming is to create a neutral surface to provide the longest possible lifespan and the most aesthetic finish for further coatings. Montana-Cans Primers are for pre-treatment and preparation of surfaces and will offer the greatest adhesion and protection to apply further coatings onto.

Pls Note:

This technical application information is given to the best of our knowledge. However, it is only intended as non-binding information and does not release you from the obligation to carry out your own tests on the products supplied by us to determine their suitability for the intended applications. Application and processing are beyond our control and are therefore in the responsibility of the user. Montana Cans shall be released from liability

unless the liability-based incident is caused by a fault incurred to Montana Cans.

Did this answer your question?